##1## is an integrated serial input / output common-cathode display driver, it connects the micro cessor 7-segment digital LED display with 8 digits, you can also connect a bar graph display or 64 independent LED. Thereon including a B-type BCD encoder chip, multi-channel scanning loop segment word driver, but also a static RAM 8 * 8 for storing each data. Only one external register is used to set the segment current of each LED.
A convenient four-wire serial interface can be connected to all general-purpose micro cessor. Each data can be addressed in the update do not need to rewrite all of the display. MAX7219 also allows each user to select a data coding or non-coding.
The entire apparatus 150A includes a low-power shutdown mode, analog and digital brightness control, a scan-limit register allows the user to display data bits 1-8, and one for all LED luminescence detection mode.
It requires only three IO ports to drive a dot matrix! No flicker when the dot matrix display! Support cascading!
This price is the price DIY kit, the price is not finished!
Disclaimer: To ensure that all components are , PCB board after all the test stand test,the physical connection is good. Welding risk, a welded, do not accept returns. But we can help customers debugging, maintenance, back and forth by the customer!
1. A single module can drive a total of 8 * 8 dot matrix overcast
2. The module voltage: 5V
3. Module dimensions: length 5 cm X 3.2 cm wide and 1.5 cm high X
4. fixing with 4 screw holes, diameter 3mm, can be fixed by using our M3 pillars
5. module with input and output interfaces, support for cascading multiple modules
1. The left side of the module as an input port, an output port on the right.
2. If a single control module, simply input port connected to CPU
3. cascading multiple modules, input and output termination CPU, input the output end of the second module of the first module, the first two modules of the first three input termination module, and so on. ..
51 microcontrollers, for example:
1.VCC and GND is not reversed, it would burn the chip!
2. When using 51 SCM P0 port control, you must pull-up resistor is recommended resistance is 4.7K - 10K
3. Please insert the first lattice hole seat, and then insert the seat hole PCB board soldering. The lattice with the word side facing you, the pins surface from left to right order of 123456. PCB board 1 foot square pad!
4. The electrolytic capacitor long foot is positive, short legs is negative; ceramic capacitors without positive and negative points.
1.PCB plate 1
2.5P pin single row curved needle 2
3.24P IC socket 1
4. line MAX7219 chip 1
5.10uF electrolytic capacitors 1
6.0.1uF ceramic capacitor 1
7.10K resistor 1
8.8P hole Block 2 (pitch 2.54mm)
9.3mm 8 * 8 dot matrix a common cathode red
10. schematics, and 51 single-chip driver a
|Cash on Delivery||No|